Car alarm with 2 remotes 02090, AUTOEXPRESS

1000053094 EAN 5903293020906 From the outside, it looks like an ordinary alarm siren, which is usually chosen for a car alarm. However, this impression is wrong, because it is a full-fledged car alarm (alarm, sensor, siren). For this you have two slim remotes to control the device. Installation is done by connecting four wires. Analog alarm designed for older cars (it's easier to install a digital alarm for newer cars). How does a car alarm work? The Amio alarm has two modes of operation. In normal mode, after activating the alarm (signaling with diode and siren), the shock sensor is activated. After slightly bumping the car, the siren beeps five times. For more hits (within 10 seconds), the siren beeps for 30 seconds (same way for a stronger hit). If the thief opens the door or turns on the ignition, the siren will sound continuously. There is also a special mode (activated by double pressing the activation button). In this mode, the shock sensor is inactive and the alarm will only respond to opening the door and turning on the ignition. The AMIO car alarm reacts to: door opening (10 seconds after activation) impact/shock (immediately after power-up) circuit voltage drop (after 50 seconds after power-up) ignition on (10 seconds after power-up) Shock sensor adjustment Understand se, the sensitivity level of the shock sensor in the car alarm is adjustable. It is enough to hold the button to activate the remote control of the alarm for 2 seconds (the siren will emit 5 beeps). In this mode, the activation button reduces the sensitivity, and the deactivation button increases the sensitivity of the impact sensor (there are five levels of adjustment - from off to very high sensitivity). The selected level is confirmed after 10 seconds. The factory default sensitivity is set to medium (level 3). Voltage drop sensor The car alarm will also respond if someone tampers with the power supply. The voltage drop sensor will trigger an alarm if it detects such a drop in the circuit it is feeding from. To activate this option, you must hold down the disarm button for two seconds (the siren will beep 3 times). In this mode, the activation button activates the voltage drop sensor (the siren will confirm with 1 beep), the disable button disables the voltage drop sensor (the siren will confirm with a double beep). After 10 seconds of inactivity, the settings are saved automatically. How to connect a car alarm The electrical installation is limited to connecting a few wires: orange (12V) gray (ACC, i.e. plus after the ignition) violet (door open sensor; ground) black (ground) Technical data 12V power supply frequency 433.92 MHz standby current: less than 5 mA siren volume: 110-125 dB remote control operating frequency 433.92 MHz standby current: 0 mA emergency disarm, keyfob programming , removing key fobs from memory (according to the manual) siren dimensions: 73x73x55mm (without feet) Finish Siren with built-in control panel remotes x 2 wiring harness Mounting elements Car alarm with small dimensions where the control panel is integrated with a loud siren. The kit includes two small remotes. The alarm reacts to: - door opening - shock / impact - voltage drop in the circuit - ignition key + 12V ACC Technical specifications: central unit: - voltage: 12V - frequency: 433.92 MHz - operating temperature: -40ºC + 80ºC - standby current: - siren: 110-125dB Remote: - frequency: 433.92 MHz - standby current: 0mA